Inicio - Tus Noticias de Actualidad!
Buscar :

Subcribete a nuestras noticias.


Troubleshooting AccuGrade® GPS (CD700)-No Power to the GPS Receivers




No Power to the GPS Receivers Probable Causes Display not turned onFuse blownDamaged harness or connectorUnserviceable receiver Problem IsolationEnsure that the master power switch and the ignition are turned on.

Turn on the display.

If the display does not turn on, the AccuGrade system fuse may be blown.

Repeat the steps for "No Power To The Display".

If the receivers are operating properly, return the machine to normal service.

If the receivers are not operating properly, Check that the light bars are powered.Proceed to Step 2.

If the lightbars are not powered, repeat the steps for "No Power To The Light Bars".

If the receivers are operating properly, return the machine to normal service.

If the receivers are not operating properly, proceed to Step 4.

If the light bars are powered, proceed to Step 4.

Check for Voltage on the Receiver Connector.

Measure the voltage between pin B and pin G on the harness connector for the receiver.The measured voltage should be machine voltage.

Measur ...



[Leer más ... ]





















 
This web uses cookies from own and from third parties to improve the navigation and show ads.
Accept